BoxOnPost
Free tool

Line of sight checker for MeshCore radios

Place two to six radios on the map and see which ones can reach each other, and whether hills block the signal. It shows the terrain profile, the radio path, how much of the Fresnel zone is clear, and a rough signal estimate in the same SNR numbers the MeshCore app shows.

Tap the map to place radio A, then tap again for radio B. Add up to 6 radios; every radio is checked against every other. Your antenna heights stay as you set them when you move the pins.

Radio settings

Your radios are kept in this browser and in the link. Nothing is sent to BoxOnPost. Save to file makes a .txt on your device you can open again or send to someone.

Place at least two radios to see the path.

Estimate only. BoxOnPost is not responsible for the accuracy or reliability of this tool or its results. Always confirm with a real test between the radios. Full disclaimer

How to read it

Green line: clear path with at least 60% of the Fresnel zone free. Amber: the direct line clears the ground but the Fresnel zone is partly blocked, which costs signal. Red: terrain blocks the direct line.

Where the heights come from

Canada: Natural Resources Canada, which includes tree tops and buildings along the path. United States: USGS 3D Elevation Program, detailed bare ground. Elsewhere: bare ground at about 90 m. The source is named under each result. On bare-ground data, use the "Trees and buildings" setting for a rough allowance, and treat the estimate as a best case.

Earth curvature

The profile bends the ground by the earth's curve with the usual radio factor (k = 4/3). Over 10 km that lifts the middle of the path by about 1.5 m; over 40 km by about 24 m.

Getting a useful answer

  • Measure antenna height from the ground, not from sea level. A roof antenna on a two-storey house is roughly 8 to 9 m.
  • Planning a repeater? Add it as another radio and use Straight line: put it between the two people with the ↑ ↓ buttons (for example Home → Repeater → Friend). The route is only as good as its weakest hop. Mesh shows which radios can reach each other directly.
  • Compare with a real ping. In the MeshCore app, Ping (zero hops) shows "SNR there" and "SNR back". If the real numbers are far below the estimate, look at the antenna, cable and connectors.
  • SF7 decodes down to about −7.5 dB SNR. A predicted SNR of 0 dB or more leaves a comfortable margin.

Disclaimer

This range checker is a free planning aid that gives a rough estimate. BoxOnPost makes no promise that it is accurate, complete or available, and is not responsible for the reliability of this tool, its results, or any decision, purchase or installation made using it. The map and elevation data come from third parties and can be wrong or out of date, and real signals are also affected by trees, buildings, weather, interference, antennas, cables and radio settings that the tool can't see. Always test with real radios before relying on a link. Do not use it for emergency or life-safety planning.

Map data © OpenStreetMap contributors. Terrain map © OpenTopoMap (CC-BY-SA). USGS topo map: USGS The National Map. Elevation: in Canada, CDEM and CDSM from Natural Resources Canada (Open Government Licence – Canada); in the US, the USGS 3D Elevation Program; elsewhere, Copernicus DEM GLO-90 (© ESA/DLR/Airbus) via Open-Meteo, or SRTM 90 m (NASA) via OpenTopoData. Map: Leaflet. To draw the profile, the points along each link are sent to one of these elevation services; BoxOnPost doesn't receive or store them.